(2) Door hanger rollers, made of stainless steel stick and nylon wheel with ball bearing (2) Door Stops, used to adjust and control the rolling distance. (1) Floor Guide, is installed on the floor to prevent the door from swinging to the sides and to ensure every stable and smooth movement, door bottom groove is required. (2) End caps, used to filling the rail ends. (1) Hex tools and all hardware fasteners. All parts tested with salt water spray 2.
The length of rail should be at least twice of width of door panel 3. The space between door top and roller top is 4-1/2 inch, Please leave enough space from your ceiling 4. In case of directly mounting on wall, the final gap between door and wall is about(1/2" to 15/16") which depends on door thickness Kindly reminder: 1.Only the hardware is for sale. Rail can be cut to any length. End caps are removable 4. Before installation, Measure your door height, door trim(if available) and bottom groove, Leave appropriate gap for your floor guide 5. This kit is probably Not for door trim or door casing, otherwise you may need a header(a solid wood board) for enough clearance 6. Your advice is welcome at any time. The item "European 6.6ft Stainless Steel Sliding Barn Door Bar Track Set 2x3.3ft Rails" is in sale since Friday, May 25, 2018. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "barndoorfactorydirect" and is located in Plainfield, Indiana. This item can be shipped to United States.