Material:Steel, POM ;Surface:Black -Full set hardware including:Roller4;Stop4;Spacer8;5FT track2;Track connector1;Anti-pad2;Floor guide2. If the frame thicker than 1/2, remove the frame mouldings to minimize door undercut. If you do not remove them, use extra spacers(not included) or install a piece of wood (not included) of the same thickness and length as the mouldings before installing the new hardware to ensure door undercut. Do not install directly onto drywall or other hollow wall. Such surfaces are not strong enough to support the total active weight of the track and door.
Every fastener used to attach the track to the wall must be fastened securely into a structural surface. Make door panel's wider than openning. Floor guides installed beside the openning.
Make sure the length from top of the door to the ceiling is longer than 5-7/8 for installation. Drill holes on the door panel. First center hole to the top of the door:1-9/16.Center length between two holes:3-9/16. Door panel need cut a groove for floor guide. 2 rollers and floor guide will be a triangle to keep door panel straight ¬ swing during sliding. 2pcs anti-pad installed on the top of the door can reduce gap between door and track. In case rollers fall off from track, please use them for safety reason. The item "Double Barn Hardware Bent Straight Roller Interior Wood Closet Door SlidingTrack" is in sale since Wednesday, March 18, 2020.
This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "shengyinhardware" and is located in Carol Stream, Illinois. This item can be shipped to United States.