6FT/6.6FT Soft Close Kit Including. 5FT track is one piece track and pre-drilled 16 apart holes. Can be used for studs wall that length between two studs are 16.5FT track kit can be used for door width up to 30. The T trigger may not hit with plastic soft close piece we pre-fixed on the track! Easy installation for non wooden frame around openning.
If baseboard/wooden frame thickness less than 3/5, easy installation as photo 1 left side. If baseboard/wood frame thickness more than 3/5, please add a thick gasket or wooden board on the back side of the track as photo 2. How to install barn door hardware.
How to install barn door hardware: Step1: Drill holes on the wall H is door panel's height, H+45MM(1.77) is the place we need drill holes for track to tight screws. Step2: Adjust the soft close mechanism's location to make two teeth visiable from the front side of the track(see step 7 on the photo manuel), then tight the track on the wall Step3: Drill holes on the door panel (see photo manuel step 3) and fix the wheels. Step4: The round dics are anti-pad, they can reduce the gap betweem door and track in case wheels jump off, pls definitely use them(any place on the top of the door and under the track) Step5: Hang wheels on the track.
Step6: Install floor guide on the floor under the groove of the door panel Step7: Move two soft close mechanism's teeth like option 1 Close the door, tight the T trigger on the bottom of the mechanism's teeth. Open the door, tight the T trigger on the bottom of the mechanism's teeth. Step8: Mount two stops of the two end of the track.The item "DIYHD Brushed Sliding Barn Door Hardware Two-Side Soft Closing Mechanism" is in sale since Monday, November 4, 2019. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "sliding-barn-door" and is located in Carol Stream, Illinois. This item can be shipped to United States.