Hardware Only, Not including Door Panel. Material:Steel/POM;Surface:Brushed Nickel. The gap between two doors are 2" based on the door thickness40mm(1 3/5") , we don't have better way to reduce this gap. Customers can use thickness 45mm(1 3/4) door panel to reduce a little.Our suggestion is to make door panel more wider than openning(openning/2+4) to cover the sight between two door's gap. 10FT/11FT 4 door bypass kit is 2 sets 5ft/5.5ft bypass kit with a track connector. After combined track, the track can NOT work with 16 apart studs.
Customer need pre-drill holes on track by yourself. 10FT/11FT 4 doors bypass kit including. 12FT/13FT 4 door bypass kit is 2 sets 6ft/6.6ft bypass kit with a track connector. 12FT/13FT 4 doors bypass kit including.Bypass system require high space(at least 10) from top of the door to the ceiling, pls check your openning space before order. Track had been pre-drilled 16" apart holes, can be used for 16" apart studs wall. The bypass system need drill 3 line holes on the wall. It's very important to double check the level to make all of them in same height. Door panel need to pre-cut a groove(Width 3/10";Height 1") , pls let your door maker finish this job when you order the door. How to install bypass bracket. How to install barn door hardware: Step1:(Inner door) Drill holes on the wall H is door panel's height, H+43MM(1-7/10) is the place we need drill holes for track to tight screws. Step2: Adjust stop's location, then tight the track on the wall with spacers.
Step3: Drill holes on the door panel (see photo manuel step 3) and fix the wheels. Step4: The round dics are anti-pad, they can reduce the gap betweem door and track in case wheels jump off, pls definitely use them(any place on the top of the door and under the track) Step5: Hang wheels on the track. Step6: Bypass bracket's waist-shaped hole is on same leve as inner track, so aim the waist hole at inner track's hole to find 2 upper holes location on the wall. Drill holes on the wall, and tight screws.Step7:Fix outter track on the bypass bracket with spacers. Step8:Hang outter door on the track and tight anti-pad Step9: Install floor guide on the floor under the groove of the door panel. The item "DIYHD Brushed Nickel Steel 4 Door Bypass Double Sliding Barn Door Hardware" is in sale since Wednesday, March 18, 2020. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware".
The seller is "shengyinhardware" and is located in Carol Stream, Illinois. This item can be shipped to United States.