DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism

DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism
DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism

The height from top of the door to the top of the roller is 130mm(5 3/25"), please at least 150mm(6") for installation. The gap between door and wall is 16mm(16/25") based on door thickness 40mm(1 4/7").

Door panel need to be cut a groove for floor guide, Groove Height:1"Width:3/10". 5FT/5.5FT Full set hardware including. 5FT(150m)/5.5FT(1.7m) track:1pcs. 6FT/6.6FT Soft Close Kit Including. 5FT track is one piece track and pre-drilled 16 apart holes.

Can be used for studs wall that length between two studs are 16. 5FT track kit can be used for door width up to 30. The T trigger may not hit with plastic soft close piece we pre-fixed on the track! Easy installation for non wooden frame around openning. If baseboard/wooden frame thickness less than 3/5, easy installation as photo 1 left side.

If baseboard/wood frame thickness more than 3/5, please add a thick gasket or wooden board on the back side of the track as photo 2. How to install barn door hardware. How to install barn door hardware: Step1: Drill holes on the wall H is door panel's height, H+45MM(1.77) is the place we need drill holes for track to tight screws.

Step2: Adjust the soft close mechanism's location to make two teeth visiable from the front side of the track(see step 7 on the photo manuel), then tight the track on the wall Step3: Drill holes on the door panel (see photo manuel step 3) and fix the wheels. Step4: The round dics are anti-pad, they can reduce the gap betweem door and track in case wheels jump off, pls definitely use them(any place on the top of the door and under the track) Step5: Hang wheels on the track. Step6: Install floor guide on the floor under the groove of the door panel Step7: Move two soft close mechanism's teeth like option 1 Close the door, tight the T trigger on the bottom of the mechanism's teeth. Open the door, tight the T trigger on the bottom of the mechanism's teeth.

Step8: Mount two stops of the two end of the track. The item "DIYHD Brushed Nickel Sliding Barn Door Hardware Two-Side Soft Closing Mechanism" is in sale since Monday, October 8, 2018. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware".

The seller is "shengyinhardware" and is located in Carol Stream,IL. This item can be shipped to United States.


Homepage    Sitemap    Contact Form    Privacy Policy    Service Agreement