DIYHD 10FT Brushed Nickel Steel Bypass Double Sliding barn Door Hardware One Piece Easy Mount Bypass Bracket. Hardware Only, Not Including Door Panel. Fit door thickness:13/8"1 3/4".2 rollers can hold 1 door MAX weight 198lbs. Track's two ends had pre-drill holes to combine two track together to create 10ft 2 door bypass system. Easy installation for non wooden frame around opening. If baseboard/wood frame thickness more than 3/5 or pre-drilled holes do not line up with studs, please add a wooden board on the back side of the track. 5FT Track4pcs + Track connector2+Track&Wall Connector16+ Bypass bracket8.
Bypass system require high space(at least 10) from top of the door to the ceiling, pleases check your opening space before order. The gap between two doors are 2" based on the door thickness 40mm(1 3/5") , we don't have better way to reduce this gap. Customers can use thickness 45mm(1 3/4) door panel to reduce a little. Our suggestion is to make door panel more wider than opening(opening/2+4) to cover the sight between two door's gap. Track had been pre-drilled 16" apart holes, can be used for 16" apart studs wall.
The bypass system need drill 3 line holes on the wall. It's very important to double check the level to make all of them in same height.
Door panel need to pre-cut a groove(Width 3/10";Height 1") , pleases let your door maker finish this job when you order the door. How to install bypass bracket. How to install barn door hardware: Step 1:(Inner door) Drill holes on the wall H is door panel's height, H+43MM(1-7/10) is the place we need drill holes for track to tight screws. Step 2: Adjust stop's location, then tight the track on the wall with spacers. Step 3: Drill holes on the door panel (see photo manuel step 3) and fix the wheels.Step 4: The round dics are anti-pad, they can reduce the gap between door and track in case wheels jump off, pls definitely use them(any place on the top of the door and under the track) Step 5: Hang wheels on the track. Step 6: Bypass bracket's waist-shaped hole is on same leve as inner track, so aim the waist hole at inner track's hole to find 2 upper holes location on the wall. Drill holes on the wall, and tight screws. Step 7:Fix outter track on the bypass bracket with spacers. Step 8:Hang outter door on the track and tight anti-pad Step 9: Install floor guide on the floor under the groove of the door panel. The item "10FT Brushed Nickel Steel Bypass Double Sliding barn Door Track Hardware Kit" is in sale since Thursday, September 5, 2019. This item is in the category "Home & Garden\Home Improvement\Building & Hardware\Doors & Door Hardware\Other Door Hardware". The seller is "shengyinhardware" and is located in Carol Stream, Illinois. This item can be shipped to United States.